Engine & Oil
How your engine makes power, and why oil changes matter so much.
How it works
Most car engines are four-stroke. A piston moves down and draws in air and fuel (intake), moves up and squeezes it (compression), the spark plug ignites it and the explosion pushes the piston down (power), then it moves up again to push the burned gases out (exhaust). The pistons turn the crankshaft, which sends power to the wheels. Oil is the engine's lifeblood: it keeps a thin film between moving metal parts so they never touch, carries away heat, and holds dirt in suspension until the filter catches it.
Why it wears
Oil breaks down with heat and time, collects fuel, moisture and soot, and its additives get used up. Worn oil protects less, sludge builds up, and parts wear faster. Short trips in Edmonton winters are especially hard on oil, since the engine never gets hot enough to burn off moisture.
Warning signs
When to service
Regular oil every 5,000 km or 3 months; synthetic every 8,000–10,000 km or 6 months. Check the oil level monthly. Replace the engine air filter every 20,000–30,000 km, and spark plugs on the maker's schedule, often around 100,000 km.
Go deeper: the technical details
- Viscosity grades
- In 5W-30, the 5W is how well the oil flows cold (the W is for winter), and 30 is its thickness at operating temperature, around 100 °C. A 0W oil flows much faster on a −30 °C morning, when most wear happens.
- Hydrodynamic lubrication
- At speed, the spinning crankshaft drags oil into a wedge that lifts it off the bearing on a film only a few thousandths of a millimetre thick. Metal-to-metal contact happens mainly at startup, before pressure builds.
- Conventional vs. synthetic
- Conventional oil is refined crude with uneven molecules; synthetic is built with uniform molecules, so it flows better cold, resists breaking down when hot, and lasts longer. A synthetic blend mixes the two.
- Additives
- Detergents and dispersants hold soot and sludge in suspension; anti-wear additives such as ZDDP form a protective layer on cams and lifters; viscosity improvers keep the oil from thinning too much when hot.
- Compression and ignition
- Typical compression ratios run about 9:1 to 12:1. Fuel that ignites too early under compression causes knock, which the knock sensor detects so the computer can retard timing.
- Turbo and direct injection
- Turbos spin over 100,000 RPM on an oil-fed bearing, so they need clean, quality oil. Direct-injection engines can push fuel into the oil, thinning it, which is one reason oil change intervals matter.
General information for typical vehicles. Your owner's manual may call for different intervals. See also our maintenance schedule and warning lights guide.
Need a hand with it?
Due for an oil change, or hearing a tick or knock? Book in and we'll look after it.