Mon–Fri 9 AM – 5 PM  ·  Sat 9 AM – 1 PM (Walk-Ins)  ·  9129 111 Ave NW, Edmonton Call 780-471-2100  |  Text 780-471-2105
Home  ›  How Your Car Works  ›  Fuel System

Fuel System

How fuel gets from the tank into your engine, in just the right amount.

How it works

An electric pump inside the gas tank sends fuel forward through the fuel lines and filter to the fuel injectors. The engine computer opens each injector for a few thousandths of a second at exactly the right moment, spraying a fine mist that mixes with air. Sensors measure incoming air, oxygen in the exhaust and engine temperature, so the computer can keep the air-fuel mix just right.

Why it wears

Fuel pumps run hot when the tank is often near empty, since the fuel cools them. Injectors build up carbon deposits. Filters clog. Moisture in the tank can freeze in winter.

Warning signs

Watch for: Hard starting, stalling, hesitation or stumbling when accelerating, rough idle, a whining noise from the tank, a fuel smell, worse fuel economy, or the check engine light.

When to service

Keep the tank at least a quarter full, and half full in winter. Replace the fuel filter per your maker's schedule if it's serviceable. Use quality fuel; an injector cleaning service can help higher-kilometre engines.

Go deeper: the technical details
Air-fuel ratio
The ideal mix for complete burning is about 14.7 parts air to 1 part fuel by weight (stoichiometric). The oxygen sensors let the computer adjust many times a second to stay near it.
Fuel trims
The computer's short- and long-term corrections show how much fuel it's adding or removing. Large positive trims point to vacuum leaks or weak fuel delivery; large negative trims to leaking injectors or high pressure.
Port vs. direct injection
Port injection sprays into the intake at about 40–60 PSI and washes the intake valves clean. Direct injection sprays into the cylinder at 2,000 PSI or more for better power and economy, but carbon can build up on the intake valves.
Evaporative system (EVAP)
Fuel vapour from the tank is stored in a charcoal canister and burned in the engine instead of escaping. A loose gas cap is a classic cause of an EVAP check engine light.

General information for typical vehicles. Your owner's manual may call for different intervals. See also our maintenance schedule and warning lights guide.

Need a hand with it?

Hard starts, stalling or hesitation? Bring it in for a diagnosis.

Book Call Text Directions